Projectiondesign F35 Betriebsanweisung PDF herunterladen (Seite 23)

english

www.projectiondesign.com

5.5 Connecting and cables

NOTE! Before setting up, switch off all equipment and disconnect the power cord.

5.5.1 Setting up a video source

For best quality video, connect a digital video source using the HDMI 1.3a interface (A) in Fig-

ure 5-4. Both HDMI inputs are HDCP copy protection compliant. Depending on cable quality,

the projector is supporting the use of cables with lengths up 20 meters (65 feet).

Figure 5-4. Connecting a video source

5.5.2 Setting up a computer source

The projector may be connected to up to four computer sources simultaneously, using the

HDMI (A) and/or DVI-D (B) interfaces, shown in Figure 5-5. These interfaces are all-digital and

will yield a projected image with very low noise.

Both DVI and HDMI are HDCP compliant with sources up to 1920x1200@60Hz (single link

source up to 165 Mhz).

Figure 5-5. Connecting a computer source

NOTE! HDCP is not supported on higher resolution sources like 2560x1600@60Hz

(WQXGA).

Connect the power cord after the DVI cable is inserted properly.

5.5.3 Connecting command and control interfaces

The projector is supporting RS-232 and LAN command and control interfaces. Use the ASCII

based, simple instruction set (SIS) protocol to communicate with the projector. A detailed

description of the ASCII protocol is available for download at www.projectiondesign.com.

Connect the power cord after the selected command and control cables are inserted

properly.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Keine Kommentare

Projectiondesign F35 Betriebsanweisung Seite 23